Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
21 years ago

Nios II Recovery Problem

I've bought Nios I development board(Cyclone Edition), and I want to upgrade it to Nios II now. I did as the mnl_nios2_board_cyclone_1c20 instructed to write the restore_cyclone_1c20.flash t...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
21 years ago

...about the "X" commands for the webserver:

These are still supported. The factory safe design no longer runs GERMS explicitly (as Kerri mentioned this is for legacy support), but the 'X' commands were carried fwd to allow you to setup your own IP address, etc... you can just type "h" at the factory-safe design console prompt (accessible via nios2-terminal) to get a list of comands.. xip, xip:123.123.123.123, etc.