Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

Nios II IDE

Sir, i hv created a SOPC design using nios II (s) , jtag, sdram,pio,timer,sysid using Quartus 7.2 and trying to run hello program on this design using Nios IDE 7.2 . Build is successful, however ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

Sir,

1. Project is launched by following steps.

. SOPC is built using Quartus II

. Bdf file created in quartus II and compiled.

Program 'SOF' file on FPGA cyclone II board.

NIOs II IDE launced thru SOPC builder then .PTF file selected of corresponding SOPC and 'hello' file program selected and then build the program to run on NIOS processor.

2. JTAG interface is used to connect to FPGA.

3. I dont undertandhow the debugger is rcognized.

Thx