Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

NIOS II EPCS Booting and export of pins

Good morning folks, I am attempting my first NIOS boot from EPCS device for cyclone II and have hit upon a problem. I connect the EPCS controller (from the moemory interfaces -> flash) section...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

In Cyclone 2 you don't have to assign epcs pins in the pin planner. It seems that Quartus automatically routes this pins to the epcs controller. Only in Cyclone 3 and 4 subfamilies you have to make pin assigments of the epcs chip.