Neek

Hippo

I have downloaded neek_web_server_mmu.zip and took the custum_fpga.h from the archive and placed it in:

~/nios2-linux/linux-2.6/arch/nios2/include/asm

with make menuconfig, changed to custom FPGA

ran make

with the resulting linux.initramfs.gz and

cycloneIII_embedded_evaluation_kit_web_server.sof (renamed to neek.sof)

from neek_web_server_mmu.zip I tried the steps below, but the LCD on the NEEK stays blank and nios2-terminal reports nothing

Any ideas?

[NiosII EDS]$ nios2-configure-sof /cygdrive/c/NEEK/neek.sof

Info: ************************************************** *****************

Info: Running Quartus II Programmer

Info: Command: quartus_pgm --no_banner --mode=jtag -o p;c:/NEEK/neek.sof

Info: Using programming cable "USB-Blaster [USB-0]"

Info: Started Programmer operation at Tue Nov 24 15:39:56 2009

Info: Configuring device index 1

Info: Device 1 contains JTAG ID code 0x020F30DD

Info: Configuration succeeded -- 1 device(s) configured

Info: Successfully performed operation(s)

Info: Ended Programmer operation at Tue Nov 24 15:39:58 2009

Info: Quartus II Programmer was successful. 0 errors, 0 warnings

Info: Peak virtual memory: 64 megabytes

Info: Processing ended: Tue Nov 24 15:39:58 2009

Info: Elapsed time: 00:00:07

Info: Total CPU time (on all processors): 00:00:03

/cygdrive/c/altera/90/nios2eds/examples

[NiosII EDS]$ nios2-download -g /cygdrive/c//NEEK/linux.initramfs.gz

Using cable "USB-Blaster [USB-0]", device 1, instance 0x00

Pausing target processor: OK

Initializing CPU cache (if present)

OK

Downloaded 3019KB in 52.1s (57.9KB/s)

Verified OK

Starting processor at address 0xC0000000

/cygdrive/c/altera/90/nios2eds/examples

[NiosII EDS]$ nios2-terminal

nios2-terminal: connected to hardware target using JTAG UART on cable

nios2-terminal: "USB-Blaster [USB-0]", device 1, instance 0

nios2-terminal: (Use the IDE stop button or Ctrl-C to terminate)