Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
21 years ago

JTAG stop working

I don't know why the JTAG stoped working ... I'm using Microtronix's Cyclone EP1C20. When I try to upload to the board, I got these messages : - inside Nios SDK 5.0.1 Build: 86, u...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
20 years ago

--- Quote Start ---

originally posted by arthur@Sep 8 2005, 06:40 AM

i don't know why the jtag stoped working ... i'm using microtronix's cyclone ep1c20.

when i try to upload to the board, i got these messages :

- inside nios sdk 5.0.1 build: 86, uploading the kernel :

------------------------------------------------

microtronix linux extensions

version 1.4, built june 20, 2005

------------------------------------------------

06/09/2005 20:44:05 - (info) nios2-flash-programmer: launching quartus programmer to download:

d:/programas/altera/nios/components/altera_nios_dev_board_cyclone_1c20/system/altera_nios_dev_board_cyclone_1c20.sof

error: can't scan jtag chain. error code 87.

06/09/2005 20:44:06 - (severe) nios2-flash-programmer: unable to download sof: d:/programas/altera/nios/components/altera_nios_dev_board_cyclone_1c20/system/altera_nios_dev_board_cyclone_1c20.sof, exiting

i have tryed to auto-detect the hardware in the quartus ii programmer, and it say to me :

unable to scan device chain. can't scan jtag chain.

i dont remember where these showed up too:

error: can't access jtag chain

error: operation failed

i dont know what to do. i have tryed to set the jumpers back to the default, as is in cyclone data sheet. everything seems normal. i can not upload the kitchen_sink core, because the erros of jtag smile.gif , so i can't test it.

any suggestions ??

regards.

arthur.

<div align='right'><{post_snapback}> (index.php?act=findpost&pid=9640)

--- quote end ---

--- Quote End ---

I have the same problem on the same Board....!!

Can you help me