I2c

Thank u.

while flashing from onchip memory through (usb blaster ii) in cyclone iii fpga quartus 13.1 version.

while converting hex and sof files to pof file.

error :

data overlaps between adderess 0 and 8.is coming. can u pls help me with this error

sry for late reply ,

I,referred from below attached document pg no:255,5.2.1.3 could i make flash from that. pls help me

hi , i referred the document we have an external nor flash ic for booting .

we have on chip ram ip for copying the flash code . but i have to boot based on external pin .

what should be used for my project,

1. memory based boot copier

or

2. alt_load_function based

i think i had to use memcopy based boot copier because i have to boot based on external pin triggering.

so, how do i create memory based boot copier in the code .

can u give a solution .

hex file generated from nios ii command shell with a width =8 and added for generation of pof file .

it showing no error pof file is generating .

while generating from make target (mem_init_generate) hex file is generating but on adding to generate pof file ( error: data in hex file overlaps between address 0 and 8)is showing.

i am toggling a pin in .sof file and another pin in .hex file . i am not added generic tristate controller and conduit bridge.

but i loaded the pof file through usb blaster ii .

on power on pin which i toggling in .sof file is toggling but in .hex file another pin i toggled is not working

how to generate .sh file in nios ii.

okay but based on external pin basis i have to execute my code.