Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
19 years ago

I didn't geting terminal mode

dear sir

i have problem with the following : after we seting the build the kernel config seting the NIOSII cyclone board statement shown below:

[sopc]=$nios2-flash-programmer --base =0x0000000 vmlinux.flash

out put : using cable "ByteblasterII [lpt1]",device 1,instance 0x00

resetting and pausing target processor:OK

checksum took 1.1s

Erased 1792kb in 20.3s(88.2 kb/s)

programmed 1875kb in 76.4s(24.5kb/s)

leaving target processor

paused the task exit

[sopc]=$

please help me i hope to get the replay as soon as possible ?

2 Replies

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    19 years ago

    Did you remember to start a nios2-terminal session?

    Try this (within NiosII IDE shell)... 

    nios2-download --go vmlinux; nios2-terminal
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    19 years ago

    --- Quote Start ---

    originally posted by hootsmon@Mar 21 2006, 05:11 AM

    did you remember to start a nios2-terminal session?

    try this (within niosii ide shell)... 

    nios2-download --go vmlinux; nios2-terminal

    <div align='right'><{post_snapback}> (index.php?act=findpost&pid=13616)</div>

    --- Quote End ---

    hi

    i have recived your replay but i have doubt i have

    1.NiosII evaluation board

    2.USB cable

    3.Altera design software suit

    4.NiosII evalution kit user guide

    5.Nios II embedded processor Evalution edition

    6.Quartus II web edition software

    I dont have the following

    1.Ethernet cable

    2.Ethernet cable crossover connector.

    can help me without the Ethernet we can work it or not ?