Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
20 years ago

I can't load my NIOS II application

Hi, When I run debug (custom board), IDE writes: Using cable "USB-Blaster [USB-0]", device 1, instance 0x00 Resetting and pausing target processor: FAILED Leaving target processor paused ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
20 years ago

I agree, it's no so good about not drive nios reset pin, but in our preview board it works - after ConfigDone, Nios starts from reset address.

But, if no driving reset pin maby cause in my case? Probably JTAG is reseting NIOS internally.