Help with Nios design

Question

I am trying to figure out how to implement a nios II embedded system which uses a USB connected keypad and displays input to the LCD monitor on the DE2 board. I am new to using the Nios processor and I am a little overwhelmed. If anyone has relevant design tutorials or help in any form it would be greatly appreciated

Thanx

altera_forum · Answer

Make this web page your new best friend:

http://www.altera.com/literature/lit-nio2.jsp

Towards the bottom you'll see a section entitled "Embedded Design Handbook":

http://www.altera.com/literature/hb/nios2/edh_ed_handbook.pdf

Should prove useful. While Nios development is very user friendly, you should not expect to pick it up overnight without a little reading.

Have fun,

Jake

Forum Discussion

Help with Nios design

1 Reply

Recent Discussions

NiosV and juart-terminal

Nios V license

NIOS does not start after SW download (timing issue?)

DK-DEV-AGI027-RA: JTAG chain broken after Nios V Hello, FPGA recovery fails

Ashling RISC Free IDE fails to download ELF file