Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
21 years ago

Has anyone else had problems with POSIX threads?

Hi I have made an app with 2 POSIX threads for my linux kernel(2.6 microtronix). When I establish my 2 pthread_t varibles the kernel simply reboots. The uClibC has built in support for POSI...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
21 years ago

Hi Wentao, ken and others

Wentao :

Have tried with malloc same old problem still.

Something new I have noticed is when I terminate my nios2-terminal app the kernel boots just fine(I think). I say this because the LEDs begins the binary count. The second I connect to the board again the kernel reboots!!! The kernel just keeps on rebooting while I'm connected. The second I then disconnect the binary count on the LEDs begins again. Very strange I think.

Some ideas???

How do I change the microtronix linux kernel so that it uses the serial IF as printf instead of the JTAG.

Regards

GreateWhite.DK