Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
20 years ago

EPCS boot understanding

Hi guys, I have a 2C8 board with a EPCS4 flash for FPGA configuration and software. Now I trying to get both in the flash: SOF conversion: sof2flash --epcs -input=nem2.sof --output=nem2....
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
20 years ago

Hi Jesse & smcnutt,

thanks for your answers. I did it like the way u showed. But it seems that the software doesn't start. The reset-address in the SOPC builder is set to the "EPCS Controller".

Any idea about that?

thanks in advance

revolt

@smcnutt: The commands u used are not supported with the 5.1 flash-programmer.