Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributoreCOS, Cyclone I/II, and Sockets
Hello All, I am a rank newbie to both the NIOS II, and eCOS; and I was hoping that I could get some advice/pointers on how to get an IP over RF (PHY) Modem/Router working on the NIOS II wit...
Altera_ForumHonored Contributor
Honored Contributor --- Quote Start --- originally posted by smcnutt@Oct 28 2005, 01:29 PM if you can bolt-up underneath ppp, you may not have to worry about sockets ;-)
<div align='right'><{post_snapback}> (index.php?act=findpost&pid=10665)
--- quote end ---
--- Quote End --- True, except for this... --- Quote Start --- originally posted by vava@Oct 28 2005, 10:21 AM (4) have the ability to change the tx/rx channels of the rf hw via a telnet interface to the nios ii (w/separate ip address for the board)
<div align='right'><{post_snapback}> (index.php?act=findpost&pid=10661)
--- quote end ---
--- Quote End --- That telnet interface is going to have to use a socket. However, it shouldn't be particularly hard; there are several examples in the book I mentioned.
