Forum Discussion

ZhiqiangLiang's avatar
ZhiqiangLiang
Icon for Occasional Contributor rankOccasional Contributor
7 months ago

Configure NIOS firmware burning interface

Hi, I would like to run NIOS II in FPGA. I am now use Cyclone 10 LP 10CL120. I have a few questions: 1) how to enable/configure UART burning interface in Quartus Platform Designer? 2) If I don't...
Embedded Applications Layer
ZhiqiangLiang's avatar
ZhiqiangLiang
Icon for Occasional Contributor rankOccasional Contributor
7 months ago

@JitLoonL_Altera

Thank you for help!

I now can add NIOS and related interface in Platform Designer, and I am also able to build firmware in Eclipse successfully.

I get a new question:
I would like add a new GPIO to NIOS so that I can control the GPIO in C code to light the LED that is connected to FPGA pin. how to add GPIO to NIOS in Platform Designer? how to control the GPIO in C code? how to access those interface in C code? is there any example C code for reference?

  • SueC_Altera's avatar
    SueC_Altera
    Icon for Contributor rankContributor
    7 months ago

    Hi ZhiqiangLiang,

    Please start a new thread for a new question.

    Thanks,

    Sue