Forum Discussion
ZhiqiangLiang
Occasional Contributor
Occasional ContributorConfigure NIOS firmware burning interface
Hi, I would like to run NIOS II in FPGA. I am now use Cyclone 10 LP 10CL120. I have a few questions: 1) how to enable/configure UART burning interface in Quartus Platform Designer? 2) If I don't...
ZhiqiangLiangOccasional Contributor
Occasional ContributorI set RAM == 122880B, and ROM==81920B.
The question is:
I cannot set RAM + ROM = 540KB which you told me in this thread.
Even if I slight reduce RAM + ROM which is slight smaller than 540KB, I still encounter the size too big issue.
