Forum Discussion
ZhiqiangLiang
Occasional Contributor
Occasional ContributorConfigure NIOS firmware burning interface
Hi, I would like to run NIOS II in FPGA. I am now use Cyclone 10 LP 10CL120. I have a few questions: 1) how to enable/configure UART burning interface in Quartus Platform Designer? 2) If I don't...
ZhiqiangLiangOccasional Contributor
Occasional ContributorI am still facing questions when I create a NIOS in Platform Designer. I am not using Quartus 18.1.
1) when I insert NIOS II, the JTAG IP is not automatically inserted.
2) if I add a JTAG IP manually, I cannot decide which JTAG pins should be exported.
Please see the following picture:
