Forum Discussion

ZhiqiangLiang's avatar
ZhiqiangLiang
Icon for Occasional Contributor rankOccasional Contributor
1 year ago

Configure NIOS firmware burning interface

Hi, I would like to run NIOS II in FPGA. I am now use Cyclone 10 LP 10CL120. I have a few questions: 1) how to enable/configure UART burning interface in Quartus Platform Designer? 2) If I don't...
Embedded Applications Layer
ZhiqiangLiang's avatar
ZhiqiangLiang
Icon for Occasional Contributor rankOccasional Contributor
1 year ago

@JitLoonL_Altera

Thank you for your patient explanation!

1) For JTAG Programming, please refer to my picture below.

I didn't any pin which have the same name as you mentioned. Did I insert the wrong JTAG? or what should I do to insert the JTAG in Platform Designer?

2) For the IRQ column, should I change the digit number? Could you please explain what those numbers mean?