Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
21 years ago

Communication with RS232 UART

Hello, I am just trying to see some activity out of the Avalon RS232 UART. I have instrumented my board's TX and RX lines on my 232 device ands am running the simple example below( Took fro...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
21 years ago

Hello,

This turned out to be operator error.

The code example above works fine on a custom board that we are developing. The HAL approach is very clean as opposed to setting up registers for the UART. Also, I am using the Bray terminal that I saw referenced here in the forum, it is much better than Hyperterminal!

http://bray.velenje.cx/avr/terminal/ (http://bray.velenje.cx/avr/terminal/)

-Baycool