Forum Discussion
Altera_Forum
Honored Contributor
Honored Contributorboot NIOS from EPCS flash and use SDRAM to store instructions and data
Hi! In the qsys I have: 1. Clock Source 2. On-Chip Memory 3. Nios II Processor 4. System ID 5. JTAG UART 6. EPCS Serial Flash Controller 7. PIO 8. SDRAM Controller I want to use...
Altera_ForumHonored Contributor
Honored ContributorAt the moment I can not see a difference to my section mappings. I attached a part of my BSP settings where the sdram is referenced.
How do you verify in your onchip-ram based system the nios processor is booting correct from EPCS?
