Application code residing in the EPCS

The problem still active http://forum.niosforum.com/work2/style_emoticons/<#EMO_DIR#>/sad.gif

I put to board, using wires, EPCS4 instead EPCS16

An now i can program it using ActiveSerial - so it work correctly

And i try to run my project.................

BUT IDE&#39;s flash programmer still not working and trow to console next :

make: Entering directory `/cygdrive/d/ALTERA_PRJ/CYCLC6/lancelot/software/hello_led_4/Debug&#39;

Jan 13, 2005 2:59:51 PM - (INFO) nios2-flash-programmer: Launching Quartus Programmer to download:

c:/altera/kits/nios2/components/AlexBoard/system/AlexBoard.sof

Pre-Reading 0KBytes of data from U2:

|----.----+----.----|

********************* (0.969 sec).

Writing 64KBytes :

|----.----+----.----|

********************* (0.953 sec).

Verifying 64KBytes of data:

|----.----+----.----|

*********************Jan 13, 2005 3:00:00 PM - (SEVERE) nios2-flash-programmer: Verification failure after write.

make: *** [epcs_controller_boot_rom_programflash] Error 8

make: Leaving directory `/cygdrive/d/ALTERA_PRJ/CYCLC6/lancelot/software/hello_led_4/Debug&#39;

What happen ?