Honored Contributor
Honored ContributorHi rapa,
I am facing the same problem what u hv faced. I followed whatever mentioned in the link, u provided in last mail for rgmii interface with tse mac. I am also using Cyclone III Development Kit board and I am not able to ping the board. I do not see any packets from the board in the network(using TCP/IP sniffer) and no activities on TxD line. When I tried to connect PC to board(on sniffer I see it as a broadcast at ARP level.) Please help. The output is following: Running... INFO : TSE MAC 0 found at address 0x10022800 INFO : PHY Marvell 88E1111 found at PHY address 0x12 of MAC Group[0] INFO : PHY[0.0] - Automatically mapped to tse_mac_device[0] INFO : PHY[0.0] - Restart Auto-Negotiation, checking PHY link... INFO : PHY[0.0] - Auto-Negotiation PASSED MARVELL : Mode changed to RGMII/Modified MII to Copper mode MARVELL : Enable RGMII Timing Control MARVELL : PHY reset INFO : PHY[0.0] - Checking link... INFO : PHY[0.0] - Link not yet established, restart auto-negotiation... INFO : PHY[0.0] - Restart Auto-Negotiation, checking PHY link... INFO : PHY[0.0] - Auto-Negotiation PASSED INFO : PHY[0.0] - Link established INFO : PHY[0.0] - Speed = 1000, Duplex = Full Waiting for link...OK IP address: 172.194.11.100 is there any other considerations that I hv to take for rgmii interface or any other issues? please help me out.... Best regards and many thanks to all the guys for providing lot many info...
