Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
21 years ago

a problem about flash programmer

hi, all I am testing my board! my sram work well, I am testing my flash, I am using sst39vf1601-70! But when I use flash programmer to writing my flash ,nios console display: make: ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
21 years ago

hw:

I use vhdl to write and read flash successfully!

sw:

when I use SST39vf160, it has not byte pin, when I use am29lv160db, I connect the byte to high level!

cs pins of other devices are connected to high level by a pull_up resistor!

I make target_board according to altera manual!

but I didnot burn my flash by using flash programmer!

I will be crazy!!!!!!

who can help me?

mountain8848, can u tell me your e-mail? or msn? or icq?

my e-mail is [email protected]