Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
7 years ago

Triple-Speed register configuration

Hi all. I'm using tse single port rgmii arria v gx project (AN647) and configure command_config register fields via tcl scripts. Is there a possibility to configure this register in project, to avoid doing this every time after programing FPGA?

Thanks for your time.

2 Replies

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    7 years ago

    Hi,Andrey13! Can you tell me how to configure register with tcl scripts? The user guide says:

    "At the minimum, you must

    configure the following functions:

    • Primary MAC address (mac_0/mac_1)

    • Enable transmit and receive paths (TX_ENA and RX_ENA bits in the

    command_config register)"

    But I don't know how to write these registers.

    Anything can help!

    Best wishes!
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    7 years ago

    Hi, siepha. You must connect your board with JTAG interface. Then go to Qsys -> Tools -> System Console. Set the root directory with your tcl scripts "cd C:/.../sc_tcl". Then run config.tcl "source config.tcl". Good luck!