Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
9 years ago

Some trouble with HDMI RX ip core (Bitec IP core)

hi,guys I have some trouble when I used HDMI 2.0 IP CORE on my own Arroa 10 board. Nvidia GTX1060 is used HDMI 2.0 test signal source, connect to FPGA serdes pin through my own connect board. ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

--- Quote Start ---

In terms of which bit? If you could point me to a direction it would be very much appreciated!

--- Quote End ---

Hi there, I am trying to use the ATX Plls on the HDMI reference design. I have re-compiled the software to use the ATX configuration, however the TX PLLs are not getting locked.Any suggestions/information on this front?