Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
18 years ago

On chip terminations cyclone III

Is the on chip termination available on these devices good enough to eliminate external source termination? The reason I ask is that it does not look like it is being used on the kit boards - I still...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
18 years ago

This sounds a lot like what I plan to do, but because of time constraints I am thinking of using the kit board as a plug-in module to our 1st prototype.

One downside to this family and board is that it requires at least two more regulators. Did you decide to keep the 2.5v for the board/board signals or go with 3.3v?