--- Quote Start ---
As I mentioned, I'm not even getting to the point in the driver file where my own test code runs. I'm stuck in configuration at state L0. Strangely, I get to L0, then it goes through the recovery sub-state machine, and then back to L0, where I'm stuck. I found this, but editing the .qsys file didn't help:
https://www.altera.com/support/support-resources/knowledge-base/ip/2017/what-assignments-do-i-need-for-a-pcie-gen1--gen2-or-gen3-design-.html --- Quote End ---
The knowledge-base link mentioned above is only applicable for hardware test. But your case seems like is simulation.
Honored Contributor
