Forum Discussion

Honored Contributor

8 years ago

Does Seriallite III for Arria10 have programmable pre-emphasis & equalizer settings?

Hello! I am looking for a high speed serial communication between multiple FPGAs, and Seriallite fits the bill. I am using an Arria10 development board. Now, the main page for Seriallite III https...

multiple-attachments.zip34 KB

Altera_Forum

Honored Contributor

8 years ago

Hi Divya,

Yes, you can configurator the pre-emphasis and equalization setting. Please refer to the transceiver ug under Analog parameter setting. You can use the qsf to tune the analog parameter settings page 568.

https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/hb/arria-10/ug_arria10_xcvr_phy.pdf

Regards,

WaiMun

(This message was posted on behalf of Intel Corporation)

Forum Discussion

Does Seriallite III for Arria10 have programmable pre-emphasis & equalizer settings?

Recent Discussions

Cyclone-V SCFIFO with M10K/MLAB memory - adding ECC

Agilex3/5 GTS Hard Ethernet IP 10G example design pin loc and io std wanted

Agilex 7 slew rate reconfiguration

Agilex-7 AXI MCDMA for PCIe hang

Constraints not being picked for DCFIFO