Forum Discussion

Michael2021's avatar
Michael2021
Icon for Occasional Contributor rankOccasional Contributor
5 years ago

DisplayPort at non GPU mode on Cyclone 10 GX and Quartus pro 20.1

I tried to finalize design non GPU mode. doesn't provide non GPU mode example design. I can't figure it out how to connection Transceiver Native PHY Reconfiguration interface signal ( this signal i...
Michael2021's avatar
Michael2021
Icon for Occasional Contributor rankOccasional Contributor
5 years ago

Hi

I got the new board and Still doesn't work DisplayPort.

I attached two picture.

Picture 1 : cyclone 10gx transceiver PHY user Guide (20.1) page 259

Picture 1: I probing from my board.

In my system, the rx_is_lockedtodata signal is always low (it is problem)

Can you advice how to make it to work ?

My concern is rx_cal_busy and rx_analogreset signal is overlapping (?)

I didn't change anything in bitec-reconfig_alt_c10.v and xcve_reconfig_arbiter.sv.

Michael2021's avatar
Michael2021
Icon for Occasional Contributor rankOccasional Contributor
5 years ago

Hello There,

I didn't hear anything yet

Michael