Forum Discussion

LSant1's avatar
LSant1
Icon for Occasional Contributor rankOccasional Contributor
7 years ago

Arria10 EMIF Design Example Simulation

I generated the design example for Arria10 EMIF. I tried to simulate it following the instructions in the example design user guide. But I get all blank waveforms. Is there any step missing? Am I req...
LSant1's avatar
LSant1
Icon for Occasional Contributor rankOccasional Contributor
7 years ago

I was able to simulate the DDR4 preset for Intel board too. This preset does not put out anything in the transcript window for a long time. That made it look like it wasn’t working. Looking at the DDR3 simulation gave me idea about the time I should expect to see the read write transactions. So I let the ddr4 simulation run upto that point and then I started seeing the RW transactions. Again, I did not have to create any stimulus. Its built-in the example design.