Forum Discussion

LSant1's avatar
LSant1
Icon for Occasional Contributor rankOccasional Contributor
7 years ago

Arria10 EMIF Design Example Simulation

I generated the design example for Arria10 EMIF. I tried to simulate it following the instructions in the example design user guide. But I get all blank waveforms. Is there any step missing? Am I req...
Vicky1's avatar
Vicky1
Icon for Regular Contributor rankRegular Contributor
7 years ago

Hi,

"First you need to understand the working of EMIF & then you can perform simulation by forcing appropriate signal."

provide the stimulus for important signals & verify them with simulation. If you understand enough EMIF then provide full input stimulus.

For better support further, please open new thread.

Best Regards

Vikas Jathar

(This message was posted on behalf of Intel Corporation)