Forum Discussion

LSant1's avatar
LSant1
Icon for Occasional Contributor rankOccasional Contributor
7 years ago

Arria10 EMIF Design Example Simulation

I generated the design example for Arria10 EMIF. I tried to simulate it following the instructions in the example design user guide. But I get all blank waveforms. Is there any step missing? Am I req...
LSant1's avatar
LSant1
Icon for Occasional Contributor rankOccasional Contributor
7 years ago

I tried it all over again and this time I did not choose Modelsim simulator as the EDA tool in Quartus. I regenerated the IP core files, compiled the project in Quartus. Then I ran msim_setup.tcl and ld_debug. The simulation goes on for a very long time and the waveform still looks as shown in the attachment in the previous message. I used Arria10 SoC Dev Kit DDR4 HILO(x72) preset and used all the default settings.