What IP should be used to write, read and erase MT25QL512ABBE12 flash device from Cyclone V FPGA?

Question

I tried using altasmi parallel IP but when I write to the device I get an illegal write indication, even when I see in the status register that the flash is not protected. Should I use a different IP? or is there an example on how to preform write and erase operations using this IP?

I'm using quartus 18.1.

shafiqy_intel · Answer

Hi CBar-,For MT25Q flash device, I usually recommend my customer to use the following IP:ASMI II parallel IPGeneric QUAD SPI Controller II IPGeneric Serial Flash Interface (GSFI) IPFor reference design,  you can refer to following link: ASMI II parallel IP = https://fpgacloud.intel.com/devstore/platform/18.0.0/Standard/remote-system-upgrade-with-system-console-for-cyclone-10-lp/Generic Serial Flash Interface (GSFI) IP = https://fpgacloud.intel.com/devstore/platform/18.0.0/Standard/generic-serial-flash-interface-intel-fpga-ip-core-reference-design/Thanks.

Forum Discussion

What IP should be used to write, read and erase MT25QL512ABBE12 flash device from Cyclone V FPGA?

1 Reply

Recent Discussions

Question

Will serialization factor of 6 in LVDS serdes IP be supported in the future on Agilex5?

1.8 V LVDS Receiver Timing Specifications for Intel MAX 10 Dual Supply Devices

Avalon-ST configuration with Agilex 3 fails

Quartus Prime Pro 25.1 fatal error during fitter: Windows "Efficiency mode" required