Analysing a couple of schematics I found out some using this device. Declared input voltage is 5..9v. Research of datasheet for LM317 shows that Vin-Vout should be >3v. Thus it will not be possible to make 3v3 from 5v. Am I correct? Anyone has experience with it and can prove/disprove it?

There's a dropout voltage diagram in the datasheet. It clarifies that 1.7 V differential is too low if the input voltage is as low as 5V. 6V input voltage (actual minimumm, considering voltage ripple!) would be O.K. You should use a typical LDO regulator.

--- Quote Start --- There's a dropout voltage diagram in the datasheet. It clarifies that 1.7 V differential is too low if the input voltage is as low as 5V. 6V input voltage (actual minimumm, considering voltage ripple!) would be O.K. You should use a typical LDO regulator. --- Quote End --- Thank you for reply. Will LM1117-3.3 help? It seems to have 1.5v dropout. However it has 800ma...1A current rating...

Yes. Typical dropout is around 1.1 V.

--- Quote Start --- Yes. Typical dropout is around 1.1 V. --- Quote End --- Cool, thanks. Will supplied current (1A) be enough? I was trying to run Altera's power calculation spreadsheet, but do not understand how to use it... So can not answer this question myself. Q240, in max config all pins are used bi-directionally, half of CLKs are used, reference frequency is 50MHz. Can you give any estimation on the power consumption on 3v3 power rail?

Current consumption depends mainly on the actual amount of switching registers and logic cells. It can't be estimated without analyzing the design.

Using LM317 to power FPGA | Altera Community

15 Replies

Altera_Forum
Honored Contributor
14 years ago
Anyhow linear power supplies are not energy efficient
Altera_Forum
Honored Contributor
14 years ago
--- Quote Start ---
Anyhow linear power supplies are not energy efficient
--- Quote End ---

Do you have anything at the same simplicity level to propose to power FPGA?
Altera_Forum
Honored Contributor
14 years ago
http://datasheetoo.com/power-ic/switching-regulator-power-ic/3a-switching-regulator-circuit-diagram-using-lm317.html
Altera_Forum
Honored Contributor
14 years ago
maybe useful:
http://docs-europe.electrocomponents.com/webdocs/0f70/0900766b80f7030e.pdf
http://docs-europe.electrocomponents.com/webdocs/0d9e/0900766b80d9ee96.pdf
http://docs-europe.electrocomponents.com/webdocs/0f6c/0900766b80f6c3e9.pdf
Altera_Forum
Honored Contributor
14 years ago
Maxim also provides free samples of their products :)

Forum Discussion

Using LM317 to power FPGA

15 Replies

Recent Discussions

Agilex 5 FPGA EMIF: sharing LPDDR4 reference clock between Bank 3A and Bank 3B

Functional fail and suspect relate to the component

Cyclone IV GX Invalid JTAG ID Code - EPCS32

Agilex 7 - Incorrect Device ID in Programmer

MT25Q512 Programming Issue When Connected to Cyclone 10CX150Y