Forum Discussion

Honored Contributor

8 years ago

Using Cypress FX3 as device for Passive Serial

Hey, So I'm working on a setup with the Cyclone 3 (specifically EP3C5E144C8N), which uses a Cypress FX3 board as the passive serial initialisation device. Unfortunately I cant seem to get the d...

Altera_Forum

Honored Contributor

8 years ago

Hey Sherif123,

Yeah I was able to get it up and running. I actually found the following quite helpful... however this is for Xilinx FPGA for using it with an Altera took a bit of fiddling.

http://www.cypress.com/documentation/application-notes/an84868-configuring-fpga-over-usb-using-cypress-ez-usb-fx3

Kind Regards

Forum Discussion

Using Cypress FX3 as device for Passive Serial

Recent Discussions

System PLL of Agliex5 PCIE example design cannot be locked after configuration

Will serialization factor of 6 in LVDS serdes IP be supported in the future on Agilex5?

Request for Cyclone V Pinout File Information

Cyclone 10 LP's Extended Industrial parts

Request for REACH 253 Substance Certificate