Altera_ForumHonored Contributor12 years agoUse Transceivers in Cyclone V Hi I would like to know how i can connect something to the hard transceivers of the Cyclone V! My Problem: FPGA: 5CSXFC6D6F31C8NES (Cyclone V with SOC) ETH PHY: 88E1543 (Quad Serial Gi...Show More
Altera_ForumHonored Contributor11 years agoPatrick I have basically same problem. Do you have some tip about this?
Recent DiscussionsHow to tell Quartus my Arria10 target system CLKUSR frequency is 100MHz?Agilex 3 PLL in Source Synchronous mode ?writing a word to cfm1 using on chip flash ip on max10MAX10 FPGA IOs not entering Tri-state (Hi-Z)To INTEL - Request for Compliance Data from your customer