Forum Discussion

HuaHongGan's avatar
HuaHongGan
Icon for New Contributor rankNew Contributor
4 years ago

USB Blaster II is not reinitialize after done programming

I run into problem where my board is not resetting to user mode after programming the POF file using USB Blaster II AS mode. I checked the board schematic and it is matched to Figure 8-2 under: htt...
NurAiman_M_Intel's avatar
NurAiman_M_Intel
Icon for Super Contributor rankSuper Contributor
4 years ago

Hi,


Apologize for missing out your case. Please note that this case has been escalated to me.


May I know what is the FPGA and the Quartus version that was used?

Have you try to re-install the USB Blaster ii driver again?


Regards,

Nur



  • HuaHongGan's avatar
    HuaHongGan
    Icon for New Contributor rankNew Contributor
    4 years ago

    Hi Nur,

    Our products use wide variety of Cyclone Family. This issue happened on Cyclone III and Cyclone IV. I have not test on Cyclone 10LP. Currently I am using Quartus 17.1 to support Cyclone IV and newer and Quartus 12.1 for Cyclone III or older.

    I am pretty sure the USB Blaster II driver was installed under Quartus 17.1 subfolder driver.

    I have not try to re-install the USB Blaster II driver. Does Intel acknowledge this issue before and release a driver fix onto it?

    We need to get this fix and we bought 20 of this USB Blaster II for our upgrade and now this is a big issue that stop our production upgrade.

    Thanks
    Gan