Forum Discussion
lutzek
Occasional Contributor
Occasional ContributorUSB blaster alternative connector
Hello,
I'm thinking about adding smaller connector to my PCB to connect USB Blaster. so there would be small PCB with 10-pin header on the top side and small SMD connector on the bottom. I'm woried...
Hi,
The small connector means lesser pin?
I think it would be better if we could use the 5x2 header as it is required for the JTAG.
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_usb_blstr.pdf (Page 4)
Thank You.
tentner
New Contributor
New ContributorHi,
maybe this is of interest for you:
https://www.entner-electronics.com/en/eeblaster.html
We have never observed issues regarding signal integrity, to answer your question.
Regards,
Thomas
