Uploading .pof file to MAX V device without usb blaster/quartus

Question

Hello,
This is basic question which i still wondering is it possible to upload .pof file or converted .pof file to svf or anything else without usb blaster/quartus programmer ?

i mean, like microcontroller can be upload .hex file in many ways .
i want to start project "Altera MAX V programmer" base from microcontroller like STM32 or ATMEGA which has .pof file inside them and upload it to MAX V chip.
the goals is only want to update MAX V firmware without computer .

is it possible ? if so, where can i go to start? i can do microcontroller programming .

thank yoyu

fvm · Answer

you want to look for jrunner code (embedded JTAG programmer).

fvm · Answer

Also review this thread https://community.intel.com/t5/Intel-High-Level-Design/MAX-II-MAX-V-in-circuit-programming/td-p/1395657

farabi · Answer

Hello,

There are list for supported 3rd party programmer:

link : https://www.intel.com/content/www/us/en/support/programmable/support-resources/programming/third-party.html

link: https://www.intel.com/content/www/us/en/support/programmable/articles/000082045.html

regards,

Farabi

nuraiman_m_intel · Answer

We do not receive any response from you to the previous answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you

Forum Discussion

Uploading .pof file to MAX V device without usb blaster/quartus

4 Replies

Recent Discussions

JTAG Chain Broken on Agilex 7-I Dev Kit

Reset offset for Cyclone 10 GX 085

M67981 supplemental mechanical information

Trouble Getting started with Stratix 10 SOC

Timing Behavior of Remote Update IP After Reset on Cyclone 10 GX (10CX150YF672E5G)