Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Timing parameters of USB Blaster 1

I'd like to constrain the timing of the JTAG interface of my Arria 10 design for a USB Blaster Rev C (note: not USB Blaster II). However, the documentation doesn't mention any details about the timin...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

I like the very helpful "Note that the values for tdi_input_delay_*, tms_input_delay_* & tdo_output_delay_* should match the destination hardware." from that Altera support page :rolleyes:

As a starting point I think you can use the values from an Altera USB Blaster II even if you use an USB Blaster I