Forum Discussion

WOver1's avatar
WOver1
Icon for New Contributor rankNew Contributor
6 years ago

Stratix V board power cycled during fpga programming -->no longer possible to program

While programming a stratix V fpga (using JTAG) the board was unintentionally power cycled. Now it is no longer possible to access the device using the programmer. Message is 'Can`t access JTAG chain...
ShafiqY_Intel's avatar
ShafiqY_Intel
Icon for Frequent Contributor rankFrequent Contributor
6 years ago

Hi WOver1,

May I know the status of this issue?

If you have any solution, you may share it to our community here.

Thanks