Forum Discussion

WOver1's avatar
WOver1
Icon for New Contributor rankNew Contributor
6 years ago

Stratix V board power cycled during fpga programming -->no longer possible to program

While programming a stratix V fpga (using JTAG) the board was unintentionally power cycled. Now it is no longer possible to access the device using the programmer. Message is 'Can`t access JTAG chain...
WOver1's avatar
WOver1
Icon for New Contributor rankNew Contributor
6 years ago

Hi Wolfgang,

Thanks for your feedback.

So you think it is not an issue the fpga did not complete a programming cycle due to the power cycle of the board?

The USB blaster (RevC) cable is ok on other device (same type, same board type) however not on this specific device/board that had a power down/up during programming.

Wouter