Stratix 10 SX 10GBASE-R Example Design and Linux Support

Question

Hi,I am trying to add the Stratix 10 10GBASE-R Example Design into my FPGA design. Is there anyway to have the MAC recognized as an Ethernet interface in the Linux OS running on my HPS?How would I have to connect it to the HPS to make this happen?Is there support in Angstrom Linux for this or would I need to write a Linux driver to do this?Thanks,DZuck1

eberlazare_i_intel · Answer

Hi,Based on my knowledge, I am unsure if there such way to achieve that.Referring to the example below, I am unsure if it can interface to the HPS:https://www.intel.com/content/www/us/en/programmable/documentation/umc1467272429805.html#bbl1467358772221

Forum Discussion

Stratix 10 SX 10GBASE-R Example Design and Linux Support

1 Reply

Recent Discussions

Unable to Generate Valid PAM4 Eye Diagram and BER Measurements on Stratix 10 SI E-Tile Native PHY

Agilex 5 D-Series HVIO IOPLL runtime reconfiguration: C0 write succeeds, but output remains 100 MHz

Cyclon 5 tampering protection bit

PCIe Simulation using Quartus Pro 25.1.1

Is VCCPD = 3.3V and VCCIO = 2.5V allowed on an Arria V?