Forum Discussion

s10user's avatar
s10user
Icon for New Contributor rankNew Contributor
3 years ago

Stratix 10 E-tile Transceiver Native PHY : What is defination of PMA adaptaion parameters?

Please give help to know the defination of PMA adaptation paramters . GS1,GS2,RF_B1,RF_B0,RF_A,RF_P2,RF_P1,RF_P0,RF_B0T,RF_P1_MAX,etc. There is link fault on low data rate (2.4Gbps~4.98G...
Kshitij_Intel's avatar
Kshitij_Intel
Icon for Frequent Contributor rankFrequent Contributor
3 years ago

Hi,


Please check in which condition you are running the PMA Adaptation Mode. Also, ,check the PMA Initial adaptation effort status. Please refer below link for more info.


https://www.intel.com/content/www/us/en/docs/programmable/683723/current/rx-adaptation-modes.html


Please follow the PMA Bring up flow.


https://www.intel.com/content/www/us/en/docs/programmable/683723/current/pma-bring-up-flow.html


Also, please follow the steps to perform duplex adaptation.


https://www.intel.com/content/www/us/en/docs/programmable/683723/current/duplex-adaptation-flow.html


Hope this will solve your issue.


Thank you

Kshitij Goel