Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

stepper motor and FPGA question about pins assignment

Hi everyone. My mission this week is to make a step motor move by FPGA I need to program the FPGA to send out a pulse, and i plan to use the clock to send a 3.3V and then connect to the stepper...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

the motor controller i am using is M542

and the FPGA i am using is the one with the chip EP1C3T100C8N

i will try to check the frequency by CRO first