Configuration using the MT25QU01GBBB8E12-0SIT

Hello,

Figure 127, "Connection Setup for Programming the EPCQ-L Using the AS Interface," in the "Cyclone® 10 GX Core Fabric and General Purpose I/Os Handbook" illustrates a configuration that enables standalone startup using the EPCQ-L via the AS interface.

However, the EPCQ-L has been discontinued; on the Cyclone 10 GX evaluation board (DK-DEV-10CX220-B), the MT25QU01GBBB8E12-0SIT is connected to the AS interface instead.

Is it possible to perform programming via Active Serial simply by replacing the EPCQ-L with the MT25QU01GBBB8E12-0SIT ?

The intended workflow is to program the 10CX220YF780E5G directly during development, and to program the MT25QU01GBBB8E12-0SIT for the final product so that the FPGA boots up automatically upon power-up.

Thank you