Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

Some of my PWM signals fed into CPLD chip are MISSING?

Hello, I connected my TI DSP TMS320LF2810's PWM signals output pins to the pins in Bank3 of my CPLD chip EPM1270F256. There are overall 6 PWM signals from DSP to CPLD chip. However, ther...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

Hi Kaz,

Sorry, I don't quite get you. Do you mean that connect all 6 DSP PWM output pins to one known PWM output pin in the DSP?

I am very sure the code is fine since I tried it in another version of my board in which I used the same DSP chip but without CPLD chip. The 6 PWM outputs are active from the DSP.

Thanks!