Forum Discussion

Yt_aem's avatar
Yt_aem
Icon for New Contributor rankNew Contributor
3 years ago

Signal Tap Start-up failure

Hi, I am using Quartus Prime Pro 19.1 and device is Cyclone 10GX150. Using SFL to program the device is successful over the JTAG (See attached SFL.png). But, when opening the Signal Tap, it keep...
sstrell's avatar
sstrell
Icon for Super Contributor rankSuper Contributor
3 years ago

Are there other devices in the Device pop-up in Signal Tap?

There could be something wrong with your .stp file. You could try creating a new one.

  • Yt_aem's avatar
    Yt_aem
    Icon for New Contributor rankNew Contributor
    3 years ago

    No, only one device. But, it does not show the part number. It supposes to have the FPGA number such as, 10CX150...(0x2E320DD) in Device.

    It looks like some settings for signal tap are wrong.

    Will recreate a new stp file again to see.

  • Yt_aem's avatar
    Yt_aem
    Icon for New Contributor rankNew Contributor
    3 years ago

    just created a new stp file and got the same failure result unfortunately after running it.