Routing differential clock to multiple ports

Question

I'm not in the position to test this,  But.. In a cyclone III, when I route a differential clock to the outputs, can I still route it to logic inside the FPGA?  All the best,

altera_forum · Answer

It's not differential until it leaves the chip, so yes you can use it internally. No different than any other clock.

Forum Discussion

Routing differential clock to multiple ports

1 Reply

Recent Discussions

NOR Flash IC programming using 3rd party Programmer

MAX10 DDR3 Timing

Agilex 3 ESD Protection

Agilex Reset_Release no associated clock

DE1-SoC project compiles, but board programming fails 42% through