Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Repair of EP1C6 and 3064 based main board. Need help!

Hello everybody, I need help. I’m repairing industry printer main board which is based on WinCE system. Main board also includes two Altera units: EPM3064ATC44-7N and Cyclone EP1C6...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Hi,

If I understood you correctly, you want to set one of the Cyclone's pin low. You can do this via boundary-scan, for example, using TopJTAG Probe software http://www.topjtag.com/probe/ (http://www.topjtag.com/probe/). Put Cyclone into EXTEST mode and you will be able to sense and control signals on its pins.