Forum Discussion

VNevř's avatar
VNevř
Icon for New Contributor rankNew Contributor
7 years ago

Remote update, unable to create factory configuration

Currently using a Cyclone V with a EPCQ256 flash. I am trying to have 2 application bitstreams and one factory bitstream with the Remote Update IP. I am unable to write the page address parameter suc...
VNevř's avatar
VNevř
Icon for New Contributor rankNew Contributor
6 years ago

I have managed to finally get the FPGA to reconfigure. I found all the information in AN 603: Active Serial Remote System Upgrade Reference Design. Even though the document is dated, the majority of information is still relevant. I have not been setting the device configuration mode as remote in the Assignments->Device->Device and pin configurations->Configuration menu.

I hope this helps anyone who is struggling with this like me.

Best,

VN