Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

Remote update controller issue

Hi everyone, I'm using the remote update controller (cyclone III) on my Cyclone IV GX dev board with a EPCS128 flash memory. I wish to have two firmwares in my EPCS (factory and application)....
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

Yes, the bootloader of QSYS works fine.

If I place my firmware at address 0, I can boot without problem.

But if I load my firmware at address 0x600000 (with the custom bootloader). When I try to reboot on, only the hardware is loading.